Home > News > Content
Rotating Seals Installation Guide
Jan 06, 2017

When installing a rotary seal (shaft lip type), the following points must be observed:

• Before mounting, clean the mounting groove. For rubber seals, the shaft and seal must be greased or oiled. • The sharp-edged transition section must be chamfered or rounded. Otherwise, cover the seal. When sealing the seal, • Do not twist the ring. • The push-in force must be applied as close as possible to the foreign seal on the seal. • After installation, the seal must be concentric and at right angles to the shaft

• The end face of the mounting hole is usually used as a contact surface; the seal can also be secured with a shoulder or spacer washer.